Once you get the speaker box out...Now comes the fun part
You will need 2 washers...I am unsure of the suze but they are fender type washers that fit the screws that come with the speaker
Next remove the speaker wire that is attached to the box...leaving just the hole... remove the mounting ring and 6 torx screws
Take you speaker wire crimp on ends and run it through the hole....
Take the speaker and put a good bead of sillicone on the mounting surface
Attach the wires and place the speaker in place...pulling out the excess wire....
Next slide the washers in place 2 for each screw on the forwaed side of the box...
Next reinstall foam and the mounting ring and sic torx screws with the speaker wire underneath... holds the wire in place
Once everything is tight using sillicone liberally fill in all the gaps between the speaker and the box...let it setup for a couple of hours then go back and using you finger...and a glove sppily a little more to make sure there are no holes....
Linear Mode
