996Previous model naturally aspirated Porsche 911 community. Discuss C2, C2s, C4, C4s, Targa and Cabriolets. Sponsored by Spec Clutch
Welcome to 6SpeedOnline.com!
Welcome to 6SpeedOnline.com.
You are currently viewing our forum as a guest, which gives you limited access to view most discussions and access our other features. By joining our community, at no cost, you will have access to post topics, communicate privately with other members (PM), respond to polls, upload content and access many other special features. Registration is free, fast and simple, join 6SpeedOnline.com today!
I did the 210 to 220 swap and if I remember correctly the was a metal sleeve that I had to take out before the 220 would slide in. It's been awhile but the sleeve is still sitting in my garage--I can take a look tonight and figure out what I did.
However, I believe the sleeve is just screwed in, and I *think* the screws are located under the two side panels where the buttons for rear window heater, TCS (on a 99), etc. are--those just pop off on a 99. If you get bold enough to try it, see if that works if not i'll check tonight...
Linear Mode
