I'm in.

 

Thanks for the support everyone. Should be testing them out next week and will go from there.

 

I'm interested too! Thanks

 

Okay everyone, we're there. Tested these out today on a 2009 V8 Vantage and we're very happy with the function. We're going to increase the diameters of the nubs a little bit so that they will stay in place while you position the jack. The hole that they go into is line with a rubber grommet/cup, which should hopefully hold them snugly enough.

The rear block has the peg perfectly centered in the cup, and it can be used on both sides of the vehicle. The front block has 2 pegs to locate the top layer, and can be lifted off and reversed to fit the opposite side.

We're confirming quantities this week, and I have been told around 2 weeks from order placement to completion. Will ship from British Columbia, Canada. I will confirm shipping costs to Continental North America tomorrow and then we will start accepting orders. If you wish to order and are outside Continental North America, please contact me by email at Stuart@VelocityAP.com and I will get a quote to ship to your location.

 

Yep I want a set of four. Will pm when they are ready.

 

Shipping sorted. Will be a flat rate $30 per pair and $45 per four for ground shipping to all US & Canadian destinations. Shipping from British Columbia, Canada.

If you're in, please send funds via Paypal to Stuart@VelocityAP.com

$120 to order a pair
$225 to order four

Please make sure your address on file with Paypal is the correct address to ship to. If not, please specify your ship to address in the note along with payment. Orders should ship in 2.5-3 weeks, depending upon how quickly we get the orders in.

 

Hi Stuart, I don't have a paypal account. Can I send you a company cheque or bank draft for ordering a set of four?
Please let me know.
Thanks!

 

Grout,
It takes 5 mins to set one up, and it it can be funded by numerous means. I use my PayPal account whenever possible as it avoids the vendor seeing any card or account numbers. Not that I'd ever expect an issue, especially with Stuart, but I just find it good practice for many reasons from security to international payments.

FF

 

Ted, I'll make you a deal. I'll deliver them to you in person at Racing for a Cure . We can settle up then.

 

I'm in for a set. When I changed the exhaust I had concerns on the lift. Will this fix that? Will it work on my lift I am putting in my new property?

 

For sure. These adapters will fit in the cups on a lift so you shouldn't need to worry any more.

 

I have 2009 DB9, Stuart or anyone can confirm that this will work on DB9. Stuart I am in Ocala, fl have you shipped it to anyone in Orlando area? I can meet up and try them on my db9 to confirm for every one.

 

I have 2009 DB9, Stuart or anyone can confirm that this will work on DB9. Stuart I am in Ocala, fl have you shipped it to anyone in Orlando area? I can meet up and try them on my db9 to confirm for every one.

 

Please do confirm, when you receive this pads I how they fit on DB9

 

I'm in for a set. But...

What's the height added to the jack to fit these in? My car is already pretty low and I have to use a set of Race Ramps just to get my car up enough to put a jack under.

Also open to suggestions for a good very-low profile jack!