You are currently viewing our forum as a guest, which gives you limited access to view most discussions and access our other features. By joining our community, at no cost, you will have access to post topics, communicate privately with other members (PM), respond to polls, upload content and access many other special features. Registration is free, fast and simple, join 6SpeedOnline.com today!
I can't say for sure, but I would highly doubt it works for anything else. The turbo is a different engine and of course has the turbo's between the exhaust and the header. It might fit in the actual exhaust 'spot' but im sure would take more fabrication than its worth to fit it up to the engine.
I would like to get this exhaust out of my garage, I'll let it go for $700 plus shipping! I stock exhaust sells for $350 around here and these tips would cost over $500 to do, you are getting the drilled cats/reworked exhaust for nothing! Any lower and I'll likely just keep it and try it out on my car when I get bored with my current.
I'll sell the ecu for $500 shipped. I'll just hold on to this if it doesn't sell for $500.
see above, exhaust was bought/taken off a Ruf 550 but there are no plates to verify. This is why I'm selling so cheap vs a used Ruf exhaust that still sells for around 3k.
pm sent -- I am in Mansfield Texas area so we are not to far from you.
__________________
08 Z06 (it's all stock I swear) To view links or images in signatures your post count must be 10 or greater. You currently have 0 posts.
Linear Mode
