997 Alcantara Interior Trim: Center Console Lid, E-brake handle, Ash Tray
#1
997 Alcantara Interior Trim: Center Console Lid, E-brake handle, Ash Tray
Category: Interior
Price: $390
Private or Vendor Listing: Private Listing
Part fits: Porsche 911 997 Turbo, Porsche 911 997 Non-Turbo, Porsche Boxter/Cayman
Location (State): CA
Item Condition: Used
Shipping Information: Item can be shipped
I have three interior/center console Alcantara trim pieces for sale. I'd like to sell them as a package, if possible. These three pieces are like-new, with barely a couple of months of use. As these pieces are rarely touched, in daily use, they are all truly in like-new condition.
The E-Brake Handle Trim and the Center Console Lid are both OEM, bought from Suncoast. The Ash Tray is the full assembly, and was made for me, using an OEM ash tray assembly, by renowned interior trim specialist Classic 9 Leather shop. It is an exact match for the OEM pieces. All are OEM black Alcantara.
I believe these will also fit any 987, but please triple check to be sure.
If bought new, these three pieces would come out to $700+. I'm asking a very reasonable $390 + shipping.
PayPal or wire transfer only, please. Thanks, 6Speed!
I will be removing these pieces tomorrow. Here they are, installed in my car. They are all truly like-new, with zero damage or signs of use:
The ash tray assembly itself shows normal wear, but the Alcantara lid is like-new in condition:
Last edited by dixans; 09-19-2014 at 02:15 AM.
#2
People have been asking, so I just want to mention how easy it is to install these pieces:
1) Hand brake trim: maybe 45 seconds. Old vinyl one pops off, and new one snaps in. No tools, no removal of surrounding trim, whatsoever.
2) Console Lid: about 10 mins. A handful of small torx screws, and that's it. Super easy to do, almost as simple as changing out a light switch cover plate.
3) Ash Tray Assembly: 30 seconds. Old one pulls right out, and new one slots right in. As easy as it gets.
Hope this helps!
Thanks, 6Speed.
1) Hand brake trim: maybe 45 seconds. Old vinyl one pops off, and new one snaps in. No tools, no removal of surrounding trim, whatsoever.
2) Console Lid: about 10 mins. A handful of small torx screws, and that's it. Super easy to do, almost as simple as changing out a light switch cover plate.
3) Ash Tray Assembly: 30 seconds. Old one pulls right out, and new one slots right in. As easy as it gets.
Hope this helps!
Thanks, 6Speed.
Thread
Thread Starter
Forum
Replies
Last Post
AJUSA.com
997 Vendor Classifieds
4
10-08-2015 05:50 PM
PelicanParts.com
997 Vendor Classifieds
0
08-20-2015 02:39 PM
PelicanParts.com
997 Turbo Vendor Classifieds
0
08-20-2015 02:38 PM
PelicanParts.com
GT3/GT2/GT Vendor Classifieds
0
08-20-2015 02:37 PM