fabspeed's enterance to the LP700 market
#1
fabspeed's enterance to the LP700 market
over the past month or so we have been developing and fabricating an exhaust for the LP700/Aventador. A good customer of ours sent us a stock exhaust to work off of and we are finally done! The setup saves 30lb off the rear of the car, has built in valves (that are controlled with a remote like our other valved exhausts), the full system is made of 14-16 gauge, C.N.C. mandrel bent T304 stainless steel tubing and is TIG welded by hand here at our shop in PA.
we don't have a video of the setup yet as we are still looking for a car to bring in to do the install on. As you can see from the cutaway of the stock exhaust, this setup will flow quite a bit better on top of saving a substantial amount of weight off the back of the car.
If an LP700 owner is interested in an exhaust system/dyno runs, let me know! the deal i would be offering you is almost too good NOT to take me up on.
cutaway of factory muffler compared to straight through design of Fabspeed x-pipe:
stock exhaust / Fabspeed exhaust comparison:
stock exhaust = 49lbs
Fabspeed exhaust = 20.5lbs
v-band flanged for factory fitment
quality of the welds
valves
investment cast/lost wax x-section
and the valve control unit and remotes:
we don't have a video of the setup yet as we are still looking for a car to bring in to do the install on. As you can see from the cutaway of the stock exhaust, this setup will flow quite a bit better on top of saving a substantial amount of weight off the back of the car.
If an LP700 owner is interested in an exhaust system/dyno runs, let me know! the deal i would be offering you is almost too good NOT to take me up on.
cutaway of factory muffler compared to straight through design of Fabspeed x-pipe:
stock exhaust / Fabspeed exhaust comparison:
stock exhaust = 49lbs
Fabspeed exhaust = 20.5lbs
v-band flanged for factory fitment
quality of the welds
valves
investment cast/lost wax x-section
and the valve control unit and remotes:
Last edited by Fabspeed Motorsport; 12-17-2012 at 11:22 AM.
#3
Yea, I think some owners jumped the gun and ordered the first setup that was released, hopefully with owners selling their coupes to get convertibles the second owner will be more interested in modding them!
Thread
Thread Starter
Forum
Replies
Last Post
Fabspeed Motorsport
Audi
0
08-21-2015 11:30 AM