Hi guys. As you can read from my posting lately I have been doing some projects. Unfortunately, I cracked mine when changing my check valve. Plastic Porsche? Anyone have their OEM one? I'm dead in the water until I find one. Any suggestions?

 

I have a oem gt2 aluminum plenum for 450 shipped

 

I have an OEM 997.1 plenum, not too sure if its the same as a 996 unit though.

 

Pmd you thanks!

 

its not the same

 

I figured it might not be. I'm going to pull mine and see what I can do first. If this is common someone needs to explore a fix .

 

the fix is moving away from plastic. get ready to bleed this is a major chore with the motor in the car. theres clamps and bolts that are almost impossible to get to. drop the motor as far as you can to get as much room as possible. your going to have to loosen at least one side of the intake manifold and those clamps are a major pia to get to. theres a straight bracket at the back that ties the 2 manis together and also very hard to reach

send me your cell. i have my motor on the table and can take pics of what needs to be removed

 

You're right pita! PMd you. So far....

 

Not too bad really. Just have to think your way through it ��

 

while you have oit apart change the oil pressure sensor on the left. cheap and easy to get to now

 

Roger that will do!

 

FWIW, these are $195 new from ECS. Went through the same a few years back