Help! Getting errors after switching DV's - Fixed
 

I just finished switching out the stock DV's with Forge DV's and after I turned on the car - I now get two errors messages after startup:

PSM Failure Drive to Workshop

and

ABS Failure

Any ideas what could have caused this? I've reconnected every hose that was disconnected by DV's while I was working. Does anyone know which pieces of the ABS and PSM system are by the DV's?

Searching through the threads I found that the MAF can cause this and I also realized I had forgotten to plug the MAF sensor back in. I've plugged it back in now but it still gives the error. Will I have to get the codes reset or does that mean there is probably still an issue?

Alright - scratch that. I hopped in the car again to go get an OBD II scanner and the messages were gone. Guess I'll consider myself lucky.

that's was the best self conversation i have ever witnessed on a forum :) you answered not one but two of your own questions!

Yeah I know - awesome, right? hilarious

I was HOPING no one would reply so it could just slowly fade out of view. :)

Nope, I saw you talk all by yourself....spooky....