Loud clicking noise from engine.. PLEASE help!
I'm getting a loud clicking noise every second from my engine.
Sounds like a missfire?? :( I recently replaced my spark plugs with Denso IK22's.. I gapped them at .30 Could that be the problem? This is really stressing me out. I haven't started my car for months and the only things I did prior to starting it was install my ECU after a flash and replace my spark plugs. I can't drive the car because there's a snowstorm. Please chime in if you can guys. Thanks in advance Update: Here's a video taken from the ride wheel well. it's the loudest from this side. http://www.youtube.com/watch?v=Z4rgv04jcHc |
Sounds similar to this.
http://www.youtube.com/watch?v=XXn1oXw_0wk Does it make the ticking noise when you first start the car? Does it change pitch when you increase the rpm's? |
I haven't checked if it changes pitch when I rev it.
But it's a loud ticking sound.. any ideas on what it could be? |
Did you check the oil?
|
My oil is always fresh because I change it every 1500kms, thx.
|
That is valve tick. Could be a number of things causing it, but I would guess a bad lifter or it's WAY out of adjustment for some reason. Could also be a rocker arm issue, but there is no doubt in my mind that it IS a valve noise.
|
I agree, after re-reading your post about the car sitting for months, I would think it was your lifters. It will probably go away after your drive it some and get the oil back into the lifters. It didn't sound like my engine.
|
It is the lifter for sure. Let her warm up a bit, rev her up and it should go away...keep your fingers crossed.
Now, this may be another issue that is more serious. My car had the same issue except it ended up being a broken valve spring and bad solenoids on the vario-cam module. I will keep my fingers crossed for you. B |
I got the same issue. So if it doesn't go away when the engine is warmed up then it's my solenoid or broken valve?
|
Originally Posted by av996tt
(Post 2288471)
I agree, after re-reading your post about the car sitting for months, I would think it was your lifters. It will probably go away after your drive it some and get the oil back into the lifters. It didn't sound like my engine.
Also, what would a missfire sound like? Thank u.
Originally Posted by BigBadBen
(Post 2288498)
It is the lifter for sure. Let her warm up a bit, rev her up and it should go away...keep your fingers crossed.
Now, this may be another issue that is more serious. My car had the same issue except it ended up being a broken valve spring and bad solenoids on the vario-cam module. I will keep my fingers crossed for you. B Thank you! |
It could just be just a sticky valve, it happens..don't panic. Mine was the actual valve spring that was broken. The valve was banging around which is why I had my motor built when EVOMS tore it a part.
Rev her up and down a few times and see what happens. Sometimes oil type/grade can have an effect on this too. Oil is a touchy subject to some. I have seen some wierd things with changing to different brands and grades. |
It just happened, have no idea why. This problem may happen if you have stored you car for a while without starting her up. That is what I was saying about the oil. It is most likely that, all the oil has drained down over time.
I usual start my car and run it to 180C on the dash (rev her a few times) every 3 or 4 weeks when it is stored just to keep her well lubed up.. Not a problem this year as she has been in warm Tempe all winter:). My garage is not heated. |
So did the loud ticking noise go away?:D...bet it did
|
Originally Posted by BigBadBen
(Post 2291433)
So did the loud ticking noise go away?:D...bet it did
I'm gonna start her up again tmw just to make sure. Thanks again for all your help and the guys that chimed in :) |
This is the first winter with the 911. My Supra was always stored for 7ish months and would start and run like I drove her everyday so I freaked out when I started the 911.
BTW: My car was at an angle.. this sounds stupid.. but could that have caused the lifters to make that ticking sound? I lowered it back down today before I started it. |
All times are GMT -6. The time now is 12:03 PM. |
© 2024 MH Sub I, LLC dba Internet Brands