A30/76
Hello,
i would like to know if someone is running A30/76 on stock maf? Thanks |
I am. I was worried about blowing mafs but EPL assured me it would be fine and Tony was right. Runs great! I had the Proto intake (Ford MAF) and hated the way it drove.
|
Originally Posted by dgreen78
(Post 3400784)
I am. I was worried about blowing mafs but EPL assured me it would be fine and Tony was right. Runs great! I had the Proto intake (Ford MAF) and hated the way it drove.
|
I run those on stock MAF. MAF blew after about 2 months on them. MAF was stock - never replaced in 10 years so it was most likely time for it to go. Car runs very smooth.
A3076 Billet Markski 900hp fuel system EPL Tune with 72# Injectors on stock FPR 1.5bar on 93 and Meth |
Originally Posted by dynamic gt2
(Post 3400799)
what boost are you running?is it on stockfuel pump?if you dont mind.Thanks
Dual in-tank pump setup like Evoms. |
Stock MAF is best for driveablity, and not sure you give up too much at a certain level. Blow through MAF MIGHT be better for higher HP levels, but driveability can't be matched by a stock MAF...
|
Originally Posted by dgreen78
(Post 3400784)
I am. I was worried about blowing mafs but EPL assured me it would be fine and Tony was right. Runs great! I had the Proto intake (Ford MAF) and hated the way it drove.
here I did Arron's car and had no issues first time with idle and drivability... Yet I know of 2 A3076s( both on 6speed running OEM maf) and from 2 different tuners and they both are having issues... In my opinion it takes a lot in either case to get it right... markski http://youtu.be/mvpiS-DD3OY http://youtu.be/j7-Ol0jaUMM |
Hitachi MAF never blows and drives like stock, imo
|
When utilizing the OEM MAF and intake platform with upgraded turbos (which I prefer after having owned both a blow-thru Ford MAF kit and back to OEM), it's best to upgrade the intake plenum and piping to allow more air flow to the turbos.
We produce a great kit for this application (pictured below), which we highly recommend for anyone upgrading turbos, while running an OEM style MAF. http://gallery.rennlist.com/albums/S...mark.sized.jpg |
Mark, that silver car looks familiar for some reason.
My blow through does drive just like stock. |
Originally Posted by ReeknHavic
(Post 3401305)
Mark, that silver car looks familiar for some reason.
My blow through does drive just like stock. its not the car its the driver :) |
Does someone tried to use a 500 ohm resistor on the maf signal wire ?
|
Originally Posted by dynamic gt2
(Post 3401669)
Does someone tried to use a 500 ohm resistor on the maf signal wire ?
|
worth it to upgrade turbos from A28s to A30/76 sure with bigger Y pipe ,fender intake and meth injection?the car already has monster ic big injectors etc.. ,,and thinking to run race pipes ,NO EXHAUST:).
Thanks |
this has been beaten to death several times, contact your tuner .
|
All times are GMT -6. The time now is 10:46 AM. |
© 2024 MH Sub I, LLC dba Internet Brands