Dual Gauge Pod for center console - Anyone sell/make them?
#1
Dual Gauge Pod for center console - Anyone sell/make them?
Looking to throw a boost gauge and AFR in the center console. Currently, I have a cubby where the ipod sits... I'd like to replace it.
I came across a few posts where people made their own, but I figured someone might have a recommendation on where I can place an order for one.
Here is what I am after (this was from a member on rennlist)
Thanks!
I came across a few posts where people made their own, but I figured someone might have a recommendation on where I can place an order for one.
Here is what I am after (this was from a member on rennlist)
Thanks!
#4
what my buddy does is buy a universal 2 pod and fiberglass onto the oem A pillar. drill 2 holes thru the A pillar for the wiring , sand and wrap or paint
#7
Pick up one of AEMs new wideband AFR and Boost gauge in one, they are pretty sweet. They have some pretty serious data logging capability too.
Trending Topics
#9
AEM gauges are nice units. Question on install and o2 wideband sensor location. Do you guys buy only one gauge/sensor setup and monitor only one exhaust bank? If only one, which exhaust bank do you monitor, drivers or passenger side? Or do you get two sets and monitor each individually?
#10
I had the same question and was told it doesn't matter.. but I feel otherwise
going to have a bung installed in each cat, not sure about doing 2 sensors... would need two gauges i'd imagine.
going to have a bung installed in each cat, not sure about doing 2 sensors... would need two gauges i'd imagine.
#11
AEM gauges are nice units. Question on install and o2 wideband sensor location. Do you guys buy only one gauge/sensor setup and monitor only one exhaust bank? If only one, which exhaust bank do you monitor, drivers or passenger side? Or do you get two sets and monitor each individually?
#12
Nice! Mind posting pictures of your setup for those of us looking for ideas
#13
Agree, the best way is egt on each individual cylinder or use Kevin's (UMW) datalogger for individual cylinder knock (pretty slick). But for now a good measure (since i technically don't have none) is to monitor the drivers side and the passenger side individually (1 wideband sensor for each side). I was looking for the 2gen Dgauge, but I can't find it anywhere since its no longer being made.
Nice! Mind posting pictures of your setup for those of us looking for ideas
Nice! Mind posting pictures of your setup for those of us looking for ideas