Problem with Oil Level indicator,Please help
 

Hello,


I have a problem in 996 Turbo with oil level sensor ,


I have message on cluster "Oil level indicator failure"


We replaced oil level sensor and oil pressure sensor and still nothing.


Any advice where could be a problem?


I have the message "Oil level indicator failure" just after oil warmed up


Thanks for advice


Rgs

Could be a wiring issue

It could be your gauge cluster computer is fried I once had the unfortunate situation of having my battery installed backwards and it fried my ability to check the oil level, North Hollywood Tach replaced my gauge cluster computer for $750. But always check the wiring to your sensors as well they could be corroded.

Good advice above.

Jak tam....

Could be few things, corroded connector, wiring, gauge cluster, and the last (ecu)....

Thanks, We will replace cluster gauge, because propably in this car somebody also has some issue during replaced battery some time ago.

Running into this same problem on a 2002 turbo. Once engine at operating temp oil level failure pops up. DId you have any success with the cluster? I have replace the level and temp sensor for the oil. Oil changed. The pressure sensor is working so I am holding off on replacing it.

I had this problem on a '02. replaced sender first and it didn't solve the problem. Wiring issue is highly unlikely. Failure turned out to be inside gauge cluster. Good luck.

Sent cluster out for repair. Fixed problem!

Oil level fault
 

[QUOTE=eurogarage;4767007]Sent cluster out for repair. Fixed problem![/hi who repaired it? I have the same problem :( thanks

hi who repaired it? I have the same problem :( thanks

North HollywoodTach Kevin

(818) 761-5137

thank you 👍😊

thank you very much can you remember the price

$750 but that was 8 years ago