Bendable tubing for bigger intake
#46
I recently updated my markski intake with some billet inlet adapters and some 3D printed clamps for the wire-reinforced tubing. Regular hose clamps just don't work nicely in my opinion. Much cleaner install now.
#47
flex tubing size for Tip. trans
I just purchased this used intake plenum etc. (take off part) from a car that just sold.
I have a tip. trans. The tubing wont fit on the drivers side due to the extra tip. mechanicals. It will get crushed at one point.
Has any one had experience in installing this unit with a tip. trans?
John @ Speedtech told me it has been done.
Thxs in advance.
P.S., If i cant get it to work I will have to sell it.
I have a tip. trans. The tubing wont fit on the drivers side due to the extra tip. mechanicals. It will get crushed at one point.
Has any one had experience in installing this unit with a tip. trans?
John @ Speedtech told me it has been done.
Thxs in advance.
P.S., If i cant get it to work I will have to sell it.
Last edited by RDS993; 03-22-2017 at 07:05 AM.
#48
I do not sell it to TIP clients as it does not fit on the drivers side. Thus, you were told right about the tubing getting crushed.
__________________
2001 996TT 3.6L and stock ECU
9.66 seconds @ 147.76 mph 1/4 mile click to view
160 mph @ 9.77 seconds in 1/4 mile click to view
50% OFF ON PORSCHE ECU TUNING BLACK FRIDAY SPECIAL
2001 996TT 3.6L and stock ECU
9.66 seconds @ 147.76 mph 1/4 mile click to view
160 mph @ 9.77 seconds in 1/4 mile click to view
50% OFF ON PORSCHE ECU TUNING BLACK FRIDAY SPECIAL
#50
I'm sure smaller piping or a silicone reduction in that spot can be made. I just never concentrated on a tip since most clients have 6speeds. I had one of these in 2002 on my 6speed.