New Control arms Vs Polyurethane bushing?
#1
New Control arms Vs Polyurethane bushing?
After installing Ohlins Road and Track coilovers with GMG sway bars my suspension started making clunking noise. At first I thought it was the sway bar link and I replaced them. It reduced some of the noise. Now I noticed that the mounting plates are not the same. The passenger side allows the coilover to drift up an extra 1 inch. I assume that the rubber bushing is damaged because of the increase tightness in the setup.
I will replace the mounts with camber plates. While doing so should I replace the old upper and lower control arms or should I order Powerflex bushing and use the old components?
Any input would be appreciated.
Thanks
I will replace the mounts with camber plates. While doing so should I replace the old upper and lower control arms or should I order Powerflex bushing and use the old components?
Any input would be appreciated.
Thanks
#2
Get the Elephant Racing camber plates - they allow for 3 times the adjustment of all others - necessary if you want to get close to OEM alignment specs with after-market suspension - better than OEM!
#3
What do you think of the powerflex bushing?
Thread
Thread Starter
Forum
Replies
Last Post
ciaka
Cayenne 955/957
4
12-05-2019 03:17 AM
Steve Jarvis
996 Turbo / GT2
8
04-06-2016 08:30 AM
Little Gator
Boxster / Cayman
1
06-23-2012 09:28 AM
VAGscum
996 Turbo / GT2
5
06-14-2011 12:05 PM