What's the going rate for meth???
#2
02-06-2019, 08:02 PM
I'm curious too- what did forum members pay to get everything installed, tuned, and up and running smoothly? Parts, labor, tuning, etc? Thanks in advance to anyone who has gone this route!
#3
02-07-2019, 01:19 PM
Depends - is it street ice, or the blue stuff? :P
From what I've gathered - to do a clean Aquamist HFS-3 / 4 install, with custom brackets for the the reservoir + pump in the frunk, gauge mounted in a pod or the glovebox, all wiring & tubing pulled through the car and hidden neatly under the car, and with injector signal + failsafe spliced into the ECU harness, you're probably looking at around 12-15 hours in labor from a shop that knows their way around the 911.
It's a pig of a job to do properly... obviously less so if you go a bit ghetto and opt for running the lines and wiring under the car instead of through it.
You'd have to check labour rates with your local shops.
From what I've gathered - to do a clean Aquamist HFS-3 / 4 install, with custom brackets for the the reservoir + pump in the frunk, gauge mounted in a pod or the glovebox, all wiring & tubing pulled through the car and hidden neatly under the car, and with injector signal + failsafe spliced into the ECU harness, you're probably looking at around 12-15 hours in labor from a shop that knows their way around the 911.
It's a pig of a job to do properly... obviously less so if you go a bit ghetto and opt for running the lines and wiring under the car instead of through it.
You'd have to check labour rates with your local shops.
The most clickbait heading in the forum.
Thread
Thread Starter
Forum
Replies
Last Post
