H&R springs - binding and both draftshafts gone
#1
H&R springs - binding and both draftshafts gone
hi everyone this Ian my first post and I知 really seeking your advice here.
Just lowered my C4S (with 35k知iles) two days ago. The Mechanic test drove the car around the parking lot and the passenger side drive shaft popped. They went to repair it and a day later the drivers side driveshaft went too.
Questions I have are:
1) Is this common when lowering the car?
2) should I revert back to stock suspension or is it fine now that they are both repaired?
3) will replacing new drive shafts help the situation ?
I never track my car so it痴 purely for cosmetic purposes. I知 quite paranoid to drive it now
4) my front springs are Super compressed and they seem to be touching / binding to each other. Is this normal behaviour ?
Just lowered my C4S (with 35k知iles) two days ago. The Mechanic test drove the car around the parking lot and the passenger side drive shaft popped. They went to repair it and a day later the drivers side driveshaft went too.
Questions I have are:
1) Is this common when lowering the car?
2) should I revert back to stock suspension or is it fine now that they are both repaired?
3) will replacing new drive shafts help the situation ?
I never track my car so it痴 purely for cosmetic purposes. I知 quite paranoid to drive it now
4) my front springs are Super compressed and they seem to be touching / binding to each other. Is this normal behaviour ?
Last edited by topofthemorning; 06-14-2018 at 12:45 AM. Reason: Detail editing
#2
Hey, I have had H&R springs installed on my previous 996.1
and now my current 997.2 C2 and have never had this happen.
Something else is going on, is your mechanic a knowledgeable
"Porsche" type?
and now my current 997.2 C2 and have never had this happen.
Something else is going on, is your mechanic a knowledgeable
"Porsche" type?
#5
Yea, this isn't right. Something is binding and cantilevering the driveshafts out. If nothing else has been corrected, it will happen again. You need to find the root cause of the issue, which is probably the incorrect springs being installed or the correct springs being installed incorrectly.
Thread
Thread Starter
Forum
Replies
Last Post
lliejk
997 Turbo / GT2
2
04-26-2018 10:12 AM
Karrera4
Chicago
13
06-11-2008 08:42 PM