I have a 2010 997.2 Turbo. I was inspecting the engine and noticed that the left side intake hose does not look completely flush against the intake box. It looks and feels secure and very tight, but looking closely, part of the rubber hose part is bent out just a bit and not completely even all around.


See attached picture where part of it curves out just a little. Is this anything to worry about? Could it be possible for this to create some kind of leak or issue later on? I just got the car with around 7,000 miles, just thought it might be better to address now if needed.


Everything feels tight on this connection but it just looked a little bent outward.


Any feedback would be appreciated.