Carbon Fiber Strakes with LED
#7
I agree if someone was to install these and make them flash like a Disco Ball it is the wrong car but if you use it as a side blinker it would be a lot nicer than anything you currently have on your car. I was looking at possibly integrating the side blinker in my mirror caps but this look also very clean. If someone is in need of a respray then they could get rid of those Ford Van blinkers on the side.
Trending Topics
#9
I agree, they should just show it as a blinker, ie.... on and off and not the wave motion. If anything other than that it screams Ricer badly or something you would get out of a J.C. Whitney catalog.
#11
Where can you buy these, I couldn't see them on Divina Tech's website?
#12
I used a controller with a wireless interface to my tablet so I can change the code without having to remove them or plug in. I put a string of RGBW led's inside the strake with a programmable controller with wifi built in. It allows small but handy functions without field wiring. The possibilities are endless, such as remote diagnostic or updates, sequence alignment between other lights in the network, dimming the running lights when the headlights come on or turning red when in sport mode.
Here's an example of the network in action across 5 controllers -
What you see in the demo's is not how I run the car on the street. Promise!! Much like our tail lights, we could have them doing anything but you have to have a bit of class with cars like ours. That's why the animated functions that are flashed are very simple and subtle on the finished item.
These aren't actually products we were planning on making. I only cast two sets of strakes with the LED cavities as a personal project for my own car. I think they are cool though
It's highly unlikely that you'll see them on the website in the near future.
Last edited by divetheworld; 02-06-2019 at 03:35 PM.
#13
My oil filler cap fits fine by the way after bit of lube
#14
That's a shame. especially if you already have the moulds to cast them. I'd be up for a set which were simple turn signal repeaters, MOT friendly, just repurpose the wire from the current blob and make a nice badge to replace it.
My oil filler cap fits fine by the way after bit of lube
My oil filler cap fits fine by the way after bit of lube
#15
Excellent )) Direction indicators would be fine, assume would flash on unlock/lock. Perhaps with a rear to front movement. And if you have a solution to remove the current repeater blob and replace it with something tasteful even better
Last edited by GT3ZZZ; 02-07-2019 at 12:29 PM.
Thread
Thread Starter
Forum
Replies
Last Post
Wheel Experts
Other British Cars
2
05-31-2012 02:53 PM