TPC Turbo Kit for 996
Category: Accessories
Price: $0
Private or Vendor Listing: Private Listing
Part fits: Porsche 911 996 Non-Turbo
Location (State): TN
Item Condition: Used
Shipping Information: Item can be shipped
Do you know how much power was added with the turbo or was it 2 turbo's? How did the car perform when you had it running?
2muchtime
Never put my car on a dyno with the turbo so I don't. The TPC kit is single turbo system. Car ran great with the turbo. Might need to upgrade your braking system though.
Here are some more pics. Haven't had time to box up yet. Turbo was wrapped up after picture and is separate from exhaust in its own box.
Never put my car on a dyno with the turbo so I don't. The TPC kit is single turbo system. Car ran great with the turbo. Might need to upgrade your braking system though.
Here are some more pics. Haven't had time to box up yet. Turbo was wrapped up after picture and is separate from exhaust in its own box.
Last edited by mattgarrett; Aug 17, 2012 at 01:36 PM.
It looks like the crash beam was eliminated / taken off to fit the exhaust/muffler (top). Very bad for insurance claim. If you were to get into a car accident (hypothetically speaking...) Heavily rear ended for instance. Once the insurance finds out that you eliminated the crash beam support and most likely they will, the claim will not be honored. That includes your car insurance and medical insurance. So mechanically and medically you're screwed....
Basically the engine will smash to your spine (depends on the circumstances) because the crash beam isn't there to absorb most of the impact. Which is design for.
Just a precaution.
Basically the engine will smash to your spine (depends on the circumstances) because the crash beam isn't there to absorb most of the impact. Which is design for.
Just a precaution.
Last edited by Black_911; Aug 17, 2012 at 02:37 PM.
You can probably contact TPC and inquire for an alternate route that can retain the crash beam... Perhaps a non=resonated pipe or straight pipe or re-routed pipe so it doesn't block the crash beam position.
My intention is nothing but good concern. You can easily sell this kit for your asking price, I'm with you on that one. But definitely contact TPC about repositioning the exhaust so the crash beam can remain and save a life or two.
I hope you don't think I'm bashing on your sale. Just safety concerns that's all.
I hope you don't think I'm bashing on your sale. Just safety concerns that's all.
is the S/C in yet? is there a thread on it? love the S/C's...
In an effort to assist with your sale, I did contact TPC Racing and the kit is transferable to a 997, however, the exhaust piping and intercooler piping will require modification. Their workload is such that they're not able to handle it at this time, although they said an experience machinist could handle this job. Obviously an ECU flash is required and I'm sure they can handle that. The crash bar with their current kits are not retained.
Good luck with the sale - great price.
Good luck with the sale - great price.
Maybe this will ease some of these saftey freaks
http://store.gospecracing.com/986-99...towhook-2.aspx
http://store.gospecracing.com/986-99...towhook-2.aspx
Maybe this will ease some of these saftey freaks
http://store.gospecracing.com/986-99...towhook-2.aspx
http://store.gospecracing.com/986-99...towhook-2.aspx
New Price $4500. It is a used system not new therefore it does have some scratches and the turbo is dull, the stainless is colored from being hot, and it is not clean like when it originally arrived. For the price you can't beat it. All you need are some good brakes to stop you and some sway bars to keep you in the curves. ;-)




Too bad you didn`t decide to sell a few weeks earlier, i would have gotten this instead of the supercharger.