A quick bump before I order ....

Does the cup lip shtick out more at the sides of the bumper ?
I'm struggling to see the difference between this and the stock gt3 lip in pictures ...

 

For track use I have a cup lip and run the std lip on the street.

its just two screws (albeit in different positions for each lip) and a few clips and takes a couple of minutes to swap over.

Cup lips will scrape on normal road use, at least with our roads

buying from any of the 3rd party suppliers is generally far less expensive than you local P Dealership and the quality is similar if not the same or better.

regards

Mike

 

Sorry Ian

I should have also answered your question

the cup lip is around 15 - 20mm deeper (i.e. closer to the ground) other than that I believe similar profile

 

+1.....

 

Thanks mike
I'll be picking one up next week sometime

 

I need one too. Would you be kind enough to post a photo?

 

I ordered both oem and cup lip. Got them from Eddie.

 

No affiliation but FVD-USA also has the Cup lip with or without brake cooling openings.

 

I only see a lip with openings for a 997.1 ??

 

You are right. Sorry.

 

whats the part number for cup lip and where can i purchase it?

 

I ordered mine from carnewal. 125 euro with or without hole. 55 euro for shipping . You can order 3 for the same shipping price and that is what i done!.
Removing my oem paint one was not easy to remove and i needed to use a flat screwdiver . The second and third tab when you start from the wheel were the hardest to remove. Front tabs were very easy and need no tool.

Put the cup lip was easy. My 8 years old helper did it!!!