I am attempting to change the valve cover gaskets and have run into a couple issues and was hoping someone more experienced can help me out. Well I got the drivers side cover loose and I am unable to get it off the engine due to not clearing the air filter box. It seems to have to come straight up due to the cam sensor in front so I am out of room. I started to remove the air box but this is no easy task either as I cannot reach the bolt on the clamp?? suggestions? Secondly on the passenger side I assume I will have the same issue, but a cannot get the last bolt on the bottom side of the valve cover near the fire wall. Using the universal plus extensions I am still unable to keep the torx in the bolt. Any ideas or suggestions? Any help would be greatly appreciated..

 

Does this link offer any help?

http://www.pelicanparts.com/techarti...cement.doc.htm