All right folks, just finished the installation of my coilovers but i am confused. I adjusted the height to get 25" 1/2 on all 4 corners, from the ground to the highest point of the fender well.

My concern is that in front, the height adjustement rings on the threaded sleeves are completly to the bottom and in the back, they are almost at the top.

I bought the set used and i am afraid i might not have the good thing, even though it fits perfect.

Can someone who installed their PSS10 confirm if they have pretty much the same thing?

If this is the way it is supposed to be, why would Bilstein put a suspension you can't lower more than 1/2" from stock in front but could raise it like 3"? And the opposite in the back, you could lower it until the wheel hits the fender well but can't raise it.

thanks for any feedback

 

I did not install my pss10...but can confirm that they are not at the limits front or back...and I am set up close to your ride height.