I just received my new Laser Jammer and I'm wondering what the best route is to get the wires to the two front sensors that need to be mounted on the bumper. I'm sure I'm not the first to do this, so I was wondering what path to take to get the wires from the inside of the car to the front bumper. I know I've seen a thread about this here before, but I can't seem to find it with the search...

 

There's a write up on RennTech in the 996 section. You need to cut a x slit in on of the 3-4" rubber grommets in the firewall and run the wires around the battery, then I can't remember the next step, but it ends up going through another grommet to come out behind the bumper. Of course the bumper needs to come off for this, but that's easy. The whole job is not as hard as you might think. Do a search in the DIY section over there for jammer installation. There's also a write up in the 996 section of Rennlist that's thorough.

 

The writeup I found on RennTech says the guy thinks he saw a writeup on 6Speedonline. Nice - chicken <-> egg.

 

I don't remember exactly where it was but it's there in one of them. Keep searching grasshopper