If I knew how to temporarily remove the protruding seat belt adjuster slider units located at the top of the door pilar, I would be able to keep the front of the roll bar legs bolted in and be able to swivel the bar back into position so that I could bolt in the rear roll bar legs. I put the question out on Renntech, but no response as of yet... "J993 indicated that I may be able to pry the adjuster unit off from the slider that is flush with the pillar. Anyone have any experience doing this or can offer any suggestions??? Thanks

In short, the rollbar install is

 

Keep the fiath Rockitman, we're counting on you.