loss of clutch pedal pressure?
Thread Starter
|
Registered User
Joined: Nov 2012
Posts: 208
From: Brick, nj
Rep Power: 38
loss of clutch pedal pressure?
The other day I went to drive the car, left over night, and the clutch pedal had 1/4 pressure. Super low engagement point in comparison to the high engagement point. I've searched but the only answers I see are bad accumulator or slave cylinder. It doesn't apply to me because I have the gt2 mod. It has a Sachs clutch and 964 rs lwfw.
No fluid inside or outside the car. Could it be a bad master cylinder? (Based on the 1 post I saw on 6speed by the owner of speedtech exhaust)
Any ideas on what to check? It's been parked since the issue. I restarted the car shortly after parking it in the garage and had full pressure again.
No fluid inside or outside the car. Could it be a bad master cylinder? (Based on the 1 post I saw on 6speed by the owner of speedtech exhaust)
Any ideas on what to check? It's been parked since the issue. I restarted the car shortly after parking it in the garage and had full pressure again.
Registered User
Joined: May 2009
Posts: 7,984
From: la
Rep Power: 608
you need to bleed the system. all you've done essentially is lose the accumulator and eliminate pentosin from the shared ps system, and now use dot4. still you have a slave and fluid, and you probably have air ( or loss of fluid? ) in the system.
GL. i have relatives in brick township. pls send them my regards.
GL. i have relatives in brick township. pls send them my regards.
Registered User
Joined: Jan 2007
Posts: 3,081
From: Omaha, NE
Rep Power: 185