I finally got around to getting my front bumper cover refinished to repair cracks in the paint that existed when I bought my car over a year ago. I've got the cover back from the body shop and am working on re-assembling the various associated pieces of trim and fasteners prior to fitting it back onto the car. No doubt I am probably being too **** about the project by following the parts diagram and having ordered in the necessary protective films and some new fasteners. On the diagram, the first protective film, part #18 is easy and goes on the bottom lip of the fender in order to protect the paint while the front bumper cover is removed and installed.

It's part #22 that has me stumped. A picture of the actual part (protective film) is below as well as its orientation on the parts diagram. It has an adhesive backing, but I'll be darned if I can determine where to install these (two are called for). Any guidance greatly appreciated!

 

It looks like it makes sense... There are two slots in the film that seem to match the contour of the plastic in the light enclosure. Doesn't it look like that when looking at the actual car?

 

Just stick on the forward facing edge, fold the rest over and under