Which of these OBD2 signals are available from the 996tt diagnostic port?

Calculated Load Value
Coolant Temp
Intake Air Temp
Long Term Fuel Trim bank 1 / bank 2
Mass Air Flow
Manifold Air Pressure
O2 Trim bank 1 / sensor 1 through bank 2 / sensor 4
O2 Voltage bank 1 / sensor 1 through bank 2 / sensor 4
RPM
Short Term Fuel Trim bank 1 / bank 2
Spark Advance
Throttle Position
Vehicle Speed

 

Well I can confirm the Mass Air Flow sensor error code, because my car threw this code when I had to replace my MAF:

P0102 - Mass Air Flow Sensor (G70) Signal Too Low"

 

Here is what I get using my pocketlogger ODBII scanner:

Calculated Load
Coolant Temperature
Short Term Fuel Trim Bank X
Long Term Fuel Trim Bank X
Fuel Pressure (Gauge)
Intake Manifold Absolute Pressure
Engine RPM
Vehicle Speed
Ignition Timing Advance
Intake Air Temperature
Air Flow Rate from MAF
Throttle Position
Oxygen Sensor Bank X Sensor Y (I only see the downstream bank 2 sensor 1 or 2 on mine, however).

 

I get the same as Ruiner.

 

A. What are you using?
B. Are you able to see your "upstream" O2 sensors? O2 1, bank 1 and O2 1, bank 2?

 

What OBII scanners are being used by most here? Would a standalone unit or laptop program with cable be a better option? Sorry to hijack.

 

A. Using the same as you ...pocketlogger

http://www.pocketlogger.com/?pid=help

B. Don't know?