hi there i have a problem i'm installing evo stage II clutch with light weight flywheel to my car but i have a problem could you guys help me with the torque recommended to tighten the flywheel cause when i spoke to the dealership overhere they told me to tighten the bolts to 25 NM i really doubt it , the number is too low especially my car is a stage 5 with 650hp the 25NM torque to the flywheel wont last a long it will break from the first run , i believe the number should be close to 70 NM could you please help on this issue by telling me what kind of torque did you guys do to your setup thanks ...

 

I would follow EVOMS's instructions. Is that what they told you?

 

I don't have the answer, but I'd recommend that you also post the question on this other site for a possible response.

Good luck!

 

the service manual says 85 Nm

 

clutch to flywheel is 23 Nm

 

 

go to http://www.imagestation.com/picture/...9.jpg.orig.jpg