VF Engineering Pulley Size v.s PSI
Thread Starter
|
Registered User
Joined: Aug 2009
Posts: 89
From: Edmonton
Rep Power: 20
VF Engineering Pulley Size v.s PSI
I have a fortified type M96 engine. I also have a VF Engineering supercharger kit. I would like to see a peak boost of 20PSI at 7400RPM. I have stock heads. Any ideas on the Vortec pulley size I would need? Maybe 1.75" ? I appreciate all input. Also I will need a good tuner. Thank you!
Last edited by 911 James; Oct 9, 2013 at 04:53 PM.
Registered User
Joined: Jun 2010
Posts: 544
From: SA, TX
Rep Power: 49
violent what have you done to you engine? I was just curious because you mentioned that you have "fortified" it. 
do you know what size pulley you are currently running on the sc? the pulley that came with the 996 kit makes about 6lbs so you could change just the sc pulley for a combination of both the crank and sc to have more room to play with tuning.
Todd K is pretty much a king with pcar tuning, but there are others out there that may be close by to your location.
do you know what size pulley you are currently running on the sc? the pulley that came with the 996 kit makes about 6lbs so you could change just the sc pulley for a combination of both the crank and sc to have more room to play with tuning.
Todd K is pretty much a king with pcar tuning, but there are others out there that may be close by to your location.
Thread
Thread Starter
Forum
Replies
Last Post
ModBargains
Audi Vendor Classifieds
1
Sep 1, 2015 05:26 PM
ModBargains
Tesla Motors Vendor Classifieds
0
Aug 20, 2015 12:28 PM
ECS Tuning - VW
VW Vendor Classifieds
1
Aug 19, 2015 11:08 AM