I ordered a stripe from porsche strip.com. I wanted to TRY one of his grafics on my doors to rear quarters. Mt stone gaurds are turning a little yellow. Am i looking for paint trouble by removing the yellowing gaurds to install the stripe without going over the gaurd. Your help would be appreciated

 

No you should be fine, just use hot water from a hose on the film for about 60 sec. peel one corner away and continue hosing while you're doing it.
It'll come of like butter.

Post some pic's when you've got the stripes installed

Good luck.

Sid.

 

If you drive your car in the winter, these should be there. Otherwise you are asking for marks... Depends on the condition of the road, but rest assured if wet, you will have high speed dirt flying on those rear panels.

My car doesnt have them, previous owner had removed them, and I need to get them back on...