Feedback on 997 Turbo Kits
Registered User
Joined: Jul 2011
Posts: 3
Rep Power: 0
Coming from a very high horsepower supercharged GTO I do like the air to water intercooler of the TPC setup. Both air to air and air to water has its benefits but my opinion (and it is just mine) is that in the rear engine setup the air to water will be more beneficial in the real world environment. The heat exchanger is out of the engine bay up front in a high velocity area. Again, just my .02.
My curent air to water setup with my TVS2300. Car made 805rwhp (stalled TH400 tranny) with 18psi boost.
Heat exchanger up front:
Water tank:
Aftercooler is sitting under that monster blower:
This was my older Vortech aftercooler setup. Made 623 rwhp thru this setup on 10lbs boost.
The car:
My curent air to water setup with my TVS2300. Car made 805rwhp (stalled TH400 tranny) with 18psi boost.
Heat exchanger up front:
Water tank:
Aftercooler is sitting under that monster blower:
This was my older Vortech aftercooler setup. Made 623 rwhp thru this setup on 10lbs boost.
The car:
Thread Starter
|
Registered User
Joined: Jun 2011
Posts: 12
From: Lisboa
Rep Power: 0
Ynot
Ynot, thanks for your info
Can you comment on fuel consumption?
TPC is well proven but I am eagerly awaiting Vivid's results
Congrats the nice GTO - wish we could get big cubes in Europe...
Can you comment on fuel consumption?
TPC is well proven but I am eagerly awaiting Vivid's results
Congrats the nice GTO - wish we could get big cubes in Europe...
Registered User
Joined: Dec 2006
Posts: 2,636
From: 5280
Rep Power: 173
Registered User
Joined: Apr 2008
Posts: 113
From: Northern VA
Rep Power: 25
I am seriously looking into turboing my Carrera and I was wondering if anyone with a turbo kit (Vivid, TPC, etc...) could share their experience.
Interesting questions are clutch life, noise, fuel consumption, assembly time, and whatever you find relevant.
Thanks for any info
Interesting questions are clutch life, noise, fuel consumption, assembly time, and whatever you find relevant.
Thanks for any info
Resolved the many issues one by one but we still have one left that leaves the car "untrackable" and pretty much worthless as a sports car. The car throws CELS every time I accelerate hard beyond 6,500 RPM due to misfiring on cylinder 4.
Moral of the story - it doesn't ALWAYS go right and even with TPC within driving distance this whole project has been a pain in the **** for all involved. Sub-moral: TPC stands behind the product and won't give up until it is right.
We will be back at it when TPC has the time to look at my car AGAIN- hopefully next week...
Last edited by Volant997; Jul 11, 2011 at 03:53 AM.
Registered User
Joined: Jun 2006
Posts: 496
From: Amsterdam Area, Netherlands
Rep Power: 43
I have no idea what conservative driving means in a 911.
Cruising on the freeway at a constant 85, I average only 20 mpg (before the turbo addition).
Is asking about fuel consumption a relevant question if you're driving a 500hp car?
Cruising on the freeway at a constant 85, I average only 20 mpg (before the turbo addition).
Is asking about fuel consumption a relevant question if you're driving a 500hp car?
Registered User
Joined: Jul 2007
Posts: 3,122
From: Natick, MA
Rep Power: 163
imho after looking for a while at different FI solutions having in mind that 90% of driving car will get on a track IMHO one should look into gt3 car, if one can afford that. or keep driving NA M96/M97 motor. there are some awesome FI track cars out there and I saw several of them but overall statistics of longivity of FI track cars are not that great IMHO. probably it has more to do with some pre-existing issues motors had before FI solution was installed, who knows.
but for a street car that is driven mostly in 2K-5K rpm range any FI will probably be fine, from what I hear issues tend to begin if car gets run at redline for long enough time at DEs. if any FI would be bullet-proof and any M97 engine would tolerate that you could be sure - any single track-built 997.1 car would have it as folks are not stupid, everyone has lust for power. nevertheless most of extensively tracked 996/997 cars do not have FI. and plenty of them are not on their first motor neither. keep that in mind.
but for a street car that is driven mostly in 2K-5K rpm range any FI will probably be fine, from what I hear issues tend to begin if car gets run at redline for long enough time at DEs. if any FI would be bullet-proof and any M97 engine would tolerate that you could be sure - any single track-built 997.1 car would have it as folks are not stupid, everyone has lust for power. nevertheless most of extensively tracked 996/997 cars do not have FI. and plenty of them are not on their first motor neither. keep that in mind.
Last edited by utkinpol; Jul 13, 2011 at 09:06 AM.
Registered User
Joined: Jul 2010
Posts: 1,229
From: Ocala, FL
Rep Power: 91
On my other highly modified car it would throw codes just because it was not within "factory" spec but according to the dyno, a/f, and tuning software everything was perfectly safe, so we shut those specific CELs off so it would not bother us. Just a few ideas.
Registered User
Joined: Sep 2007
Posts: 88
From: Slovenia
Rep Power: 23
I have also TPC turbo kit on my 996 3.6 and it is still not running well....... I still cannot get it in closed loop and my tuner says it is running lean. So my car is in work now for almost 6 months. Maybe one of you guys can point me to the problem with it :
1. Durametric or other cable did not find any problem
2. Car is running on idle too much dry
3. If you give throttle the car is stalling
I would be very happy if someone had same problems and would help me on it. If someone needs logs I can post them.
Best regards,
Kras
1. Durametric or other cable did not find any problem
2. Car is running on idle too much dry
3. If you give throttle the car is stalling
I would be very happy if someone had same problems and would help me on it. If someone needs logs I can post them.
Best regards,
Kras
Registered User
Joined: Apr 2008
Posts: 113
From: Northern VA
Rep Power: 25
Have you changed the plugs, looked at the coil pack/wire? There are not many options for a misfire code. Do you notice that it runs like crap when the light is on or just light only?
On my other highly modified car it would throw codes just because it was not within "factory" spec but according to the dyno, a/f, and tuning software everything was perfectly safe, so we shut those specific CELs off so it would not bother us. Just a few ideas.
On my other highly modified car it would throw codes just because it was not within "factory" spec but according to the dyno, a/f, and tuning software everything was perfectly safe, so we shut those specific CELs off so it would not bother us. Just a few ideas.
ECU Tunes x MANY + MANY More
New plugs (tried several variants)
New Coils
New Fuel Pump
New Intake Distributors
New MAF
New O2 Sensors
Currently running a tune with secondary O2 sensors disconnected and a default value hard-coded in and some "masking" around cylinder 4 which wasn't completely explained to me.
Took the car to the track two months ago, knowing it had the CEL issue. I laid off for the first two runs to try and avoid the CEL's (without much success). On the third and final run I figured I'd just go for it. 10 minutes into it the car went into "limp mode" due the excessive misfires. That was a "significant emotional event" as the car feels as if it has lost all power and shudders badly - thought I had lost the engine. It isn't feasible to just turn off the CEL's - there is something bad going on and the misfire count, when driven high enough over a time period, will put the car into limp.
Anyway - the obvious/easy stuff has been tried. Thinking now maybe a valve, or cam timing sensor...
Thanks for the suggestions - I appreciate any ideas as this has both me and TPC baffled at this point.