My entire BB phonebook syncs with the PCM just fine, but if using the toggle under the turn signal to search through the phonebook, I am limited to 0-9 A-D.

In other words, after engaging phonebook at the on-board computer display, if I hold the toggle arm down it will toggle through the first couple of numeric numbers in my phonebook, and (still holding it down) it will go to "1" then "2"...all the way through "9" then "A" then "B" then "C" then "D", then back to "1". It completely skips the rest of the alphabet. This cycle continues if you keep the toggle arm in the down position at "phonebook".

Does this sound familiar to anyone? I know the rest of my phonebook entries are loaded and updated in the PCM, but I cannot get the on-board computer display to index anything beyond "D" entries.

Any suggestions?

 

I have the same problem, too!

 

I have had teh same problem and it was because I had too many addresses.

 

that sucks. must be my problem too. Wonder what the limit is or where I might find that.

 

Since I upgraded my iPhone to the new 5.0 ver, I see a blank address book untill I scroll to a letter and then it's fine...wasn't the case before!

 

guess I would have to "upgrade" to the iPhone from my BB before I could actually upgrade my iPhone.

Just too dependent on the reliability of my BB and my enterprise NW.

 

I have a bout 6000 business card scanned into my phone....I think I can store about one half....so my gues is somewhere between 2000 and 3000. So if you are not that high it is probably something else.