LED replacement for the Headlight 5W Bulb
Hello,
I replaced the regular 5W bulb from the headlight with an LED and the sensor thinks there is no bulb, is there any solution besides installing a resistor?
I replaced the regular 5W bulb from the headlight with an LED and the sensor thinks there is no bulb, is there any solution besides installing a resistor?
Car needs to see a "load" of some type.
Bulb chart
Low beam Philips D2S 35W
Additional high beam without cornering light H11 55W
Additional high beam with cornering light H7 LL 55W
Turn signal indicator light, side WY5W
If it was the WY5W - you might check with these guys:
http://www.hoen-usa.com/city.htm
Last edited by jhbrennan; May 9, 2013 at 06:10 AM.
Where can I get it?
Which bulb did you replace?
Bulb chart
Low beam Philips D2S 35W
Additional high beam without cornering light H11 55W
Additional high beam with cornering light H7 LL 55W
Turn signal indicator light, side WY5W
If it was the WY5W - you might check with these guys:
http://www.hoen-usa.com/city.htm
Bulb chart
Low beam Philips D2S 35W
Additional high beam without cornering light H11 55W
Additional high beam with cornering light H7 LL 55W
Turn signal indicator light, side WY5W
If it was the WY5W - you might check with these guys:
http://www.hoen-usa.com/city.htm
Thread
Thread Starter
Forum
Replies
Last Post




