got my car back, the mechanic said he drove it for 100 miles and said there were no problems. i drove it for 50 miles and stopped. when i started the car, the engine ticked but didnt start. i saw there were a lot of fault codes for cylinder load. i replaced the fuse on row 4, #7, which was blown. i started it again, it ran for 10 seconds then died? Any ideas? im on the road now waiting for a tow....

 

i'm confused - what did the mechanic do to it...? (or was he simply trying to diagnose your start issues?) and did you just get it supercharged or something? or it was already supercharged and this problem just arose? a little more info might help as would any specific codes.

 

The mechanic installed the VF Engineering supercharger the other day.

Codes:
P0430 - Powertrain
Catalyst System Efficiency Below Threshold (Bank 2)

P0420 - Powertrain
Catalyst System Efficiency Below Threshold (Bank 1)

P0264 - Powertrain
Cylinder 2 Injector Circuit Low

P0261 - Powertrain
Cylinder 1 Injector Circuit Low

P0273 - Powertrain
Cylinder 5 Injector Circuit Low

P0270 - Powertrain
Cylinder 4 Injector Circuit Low

P0276 - Powertrain
Cylinder 6 Injector Circuit Low

P0267 - Powertrain
Cylinder 3 Injector Circuit Low

 

oh holy hell man, take it back to the mech! obviously something to do with install/supercharger. i thought it might be caused by something that was left loose or re-installed wrong when he buttoned the engine bay back up. sorry and good luck.

 

Yea. I'm waiting in the room now while he's looking at it. I'm just thinking the injector codes are related to electrical? I'm hoping it's something easy.

 

Mechanic found it that it was a coil pack that got melted?