I just finished up this little project. It came out nice I think. The Gen II intake is nice and flat and is really pretty cool to look at under the glass. All the parts, intake and exhaust manifolds, throttle bodies, injectors, oil pan, and spark plugs are all OEM Viper parts and could be swapped onto a Viper and work perfect. The block and heads are both resin and are fully removable. Ill probably use it for a while then sell it and move on to another similar project....I have an idea to start doing these as a hobby as I learned a LOT just from this piece. Hope you like it.

 

haha thats an awesome table. Conversations must go fast around the table. *badumchee

 

Wow that is so cool. Would you be interested in two Viper wheels I planned to either hang on the wall or make into end table with glass tops and a mock brake and rotor under? The are cut down to a few inches. There are finger prints on them in the pic but they are real nice in reality.

 

Thanks for sharing!!!

 

Thanks all!
Speedware Motorsports....its an engine stand not a hoist.

 

That is cool, nice work

 

Nice work!