FS: 996T - Fabspeed Filter, FVD Hard Pipe
Thread Starter
|
Registered User
Joined: Feb 2007
Posts: 65
From: NC
Rep Power: 22
SOLD: 996T - Fabspeed Filter
Category: Engine - Intake/Fuel
Price: $1
Private or Vendor Listing: Private Listing
Part fits: Porsche 911 996 Turbo
Location (State): NC
Item Condition: Used
Shipping Information: Item can be shipped
Last edited by Man_Car; Nov 20, 2013 at 10:35 AM. Reason: Sold
Thread Starter
|
Registered User
Joined: Feb 2007
Posts: 65
From: NC
Rep Power: 22
I sold my turbo and need to sell some leftover parts. Fabspeed intake with filter and stock rear housing - Great condition. Based on my research I have the FVD 3" hardpipe intake that mates to factory Intercooler. The hardpipe has a few marks from installation and one or two rubbed areas where it sits against the AC lines. No holes but rubbing is thru the paint and some into the metal.
Fabspeed Airfilter is $SOLD and the FVD intake is $SOLD.
Here's a pic installed together.
Fabspeed Airfilter is $SOLD and the FVD intake is $SOLD.
Here's a pic installed together.
Last edited by Man_Car; Nov 20, 2013 at 10:35 AM.
Registered User
Joined: May 2010
Posts: 1,601
From: Brampton,Ontario,Canada
Rep Power: 205
Being the Y pipe is 3" and the throttle body is smaller, is there a reducer coupler to fit down to the throttle body size?
Any thoughts on how this would fit a 82mm GT3 Throttle body?
Thanks
Bobby Ali
ba
Any thoughts on how this would fit a 82mm GT3 Throttle body?
Thanks
Bobby Ali
ba
Thread Starter
|
Registered User
Joined: Feb 2007
Posts: 65
From: NC
Rep Power: 22
The silicone coupler measures about 2 3/4 inner diameter on both ends. It was very snug on the FVD pipe and seemed to fit fine on the TB. Not sure of the outer diameter of the TB as my car is sold now. My car did have the IPD air intake plenum but the TB looked stock. Thanks..
Registered User
Joined: May 2013
Posts: 92
From: Kuwait
Rep Power: 18
Trending Topics
Thread Starter
|
Registered User
Joined: Feb 2007
Posts: 65
From: NC
Rep Power: 22
Not sure. Mine were stock as were the intercoolers. I had the IPS intake plenum, 3" hard pipe, tune, filter, diverters and exhaust. This thing ran extremely well together.
Registered User
Joined: May 2013
Posts: 92
From: Kuwait
Rep Power: 18
Weird every one i asked they said I shouldnt install ipd plenum abd 3" y pipe unless I have upgraded my turbos :/
