Doing my rear brakes and rotors, and also a flush this weekend. I did my Frits recently, so I am familiar with the pad and rotor procedure. And yes I do have the special triple square bit for the rear rotors.

Now for the flush.... Per the suggestion of renntech, I'm going to use ate 200 fluid. The master cylinder is located drivers side front, correct? So I would want to go Passenger rear, driver rear, passenger front, driver front; correct? Anything special I should know before attacking this project?

 

Also, how much fluid do you think I would need? 2 liters should be enough, right?

 

Just on can of the ATE 200 is needed, the order is to to furthest to closest so passenger rear, driver rear, passenger front driver front.

 

thanks for the tip.

does anyone know the torque specs for the mounting bolts, etc?

i did a quick search, but came up with nothing