RSS is introducing our new Adjustable Clutch Stop for those of you who have upgraded and need to limit the travel of your hydraulic clutch.

Installs directly onto the arm of the pedal in minutes.

Designed for the street and track – this has come in very handy for our RSS Tarmac Package with upgraded Tilton Clutch and Sequential Shifter system.

Made right here in sunny California, USA

Appreciate the feedback...

 

Isn't that screw head at the bottom going to wear a hole in the carpet instantly?

 

Nice looking piece, I may want to order one just to put on my desk!!

 

CMOS,

Thanks for the post. Actually the screw head is almost flat with a subtle radius curve so it wont wear a hole in the carpet instantly as your question states. We have tested this product on numerous vehicles and have not had a problem. However, it is possible to wear a hole in the carpet depending on the application and how hard the clutch is depressed. We've had people put a small, thin square of rubber, dense foam or gaffer tape where the stop hits to eliminate any worry. We have also had people actually cut a small hole in the carpet and also put a base plate in as well. This product was created to assist people who needed a quick and easy approach to limiting the travel on their clutch. The product installs in minutes and can be taken off and/or adjusted very quickly as well compared to having to fabricate or weld components for certain applications. Thanks.

 

Thanks snowboarder54, appreciate the comments... I have one on my desk as well.