Safe to assume this only works with going from a MF .1 wheel to MF .2 wheel? I have a .1 heated, non-MF wheel with the thumb shifters and the additional stalk below the wiper stalk to control the functions. I'm guessing I'd need all sorts of additional parts (if it's even possible). Thanks.

 

They can make work all combinations. Check web site, send them email and ask about.

 

New wheel
New airbag
Adapter
‘Multifunction enable code’ input and coding the steering wheel electronic module and instrument cluster by PIWIS

 

PM me if you can come to Atlanta, GA and need help with programming.

 

It looks great!
Did you used same adapter?

 

oh damn that looks so awesome.. i want to do this so bad...

 

Yes.

 

boom! done! my first reaction "this is just 'effing beautiful"

I went with the alcantara version to match the GTS interior

 

Your airbag is sticking out too much. Like 1.7mm too much. Please recheck to make sure the three standoff behind the three screws are positioned correctly on to the airbag locking plate.

 

Here is a quick snap for your reference.

 

first of all, thanks for all your help in getting this retrofit done!

second, i actually don't think the "gap" of my airbag bother me that much in person, comparing with some of the actual setup from factory, it's not that off, but I'm going back to the shop tomorrow to have them double check as well, thanks!

 

Those pictures are from two other cars. One has red guage, voice control and Adaptive Cruise. The last one does not.

 

lol of course they are different! I was showing you the airbag gap of factory installed wheel from different cars

 

Stop posting these pictures! Making me so jealous. I need somebody smarter than me in the Boston area to do this!

BTW, looks great kechang!

 

I hear you went to an independent shop to code your car to make this work. I'm located in Los Angeles so can you tell me where you went? Thanks!