Year: 2004
Make: Dodge
Model: Viper
Price: $75000
Mileage: 8900
Color: Black
Private or Dealer Listing: Private Listing
Location (State): TX
Transmission: Manual
Drivetrain: Rear Wheel Drive

VIN: 1B3JZ65Z54V101551

I’ve decided to part ways and put up for sale my immaculate and low mileage 2004 Twin Turbo Dodge Viper, that has been fully built from the ground up with best of the best parts by the original Racing Solutions that was here in Houston, TX. The factory 505ci engine has been Bored & Stoked out to 522ci engine is built to support 1500hp. Cylinder heads were Port & Polished by Greg Good, one of the BEST in the industry when it comes to Vipers! The factory T56 transmission was upgraded to the newer and stronger TR6060 transmission that came in the 2008 and newer Vipers. To top it all off, a pair of Garrett GT40r Ball Bearing Turbocharger that produces a very unique, one of a kind sound that I haven’t heard on any other turbo Vipers.

The car has always been maintained here in Houston, TX by the original tech who built it. At this time, the car needs nothing other than a new home and an owner who could enjoy and handle this 1000+ whp, beast. Runs and drives like a stock Viper until you hit boost. It’s been driven in Houston rush hour traffic without any issues such as overheating, etc.

I’ve added some new fuel system components recently within the last 500 miles, including: New fuel lines, Filters, Weldon Fuel Pump, Weldon Fuel Pump Controller and a new Boost Controller.

1,051whp on 93 octane

3 Owners, Clean Carfax & No accidents


Mods

Racing Solutions Twin Turbo System

• Garrett GT40r Ball Bearing Turbochargers
• 2 Tial MV-R Wastegates
• 2 Tial Q Blow Off Valves
• Custom Stainless Turbo Headers
• Custom Stainless V-Band Turbo Piping
• Custom Front Mount Intercooler
• 4” Stainless Exhaust
• Stainless Steel Turbo Down Pipes
• Breeze T-bolt Clamps for Intake Tubes
• Custom Heat shielding

Racing Solutions 522 C.I.D Stroker Motor

• RSI Spec Blueprint and Balanced Short block
• Custom Modified Crankshaft
• Manley Pro Forged Steel Rods
• Custom Turbo Camshaft
• JE Forged Pistons (8.5:1 compression ratio)
• JE Pro Forged Steel Wrist Pins
• Clevite Race Main Bearings
• Clevite Race Rod Bearings
• Total seal File Fit rings
• Billet Main Caps
• ATI Super Damper Harmonic Dampers
• ARP Head and Main Studs

Intake and Cylinder Heads

• Greg Good Port & Polish Cylinder Heads
• T&D Rockers
• Oversized Valves
• Dual Valve Springs
• Tool Steel Retainers
• Port Matched Intake Manifold
• Pressure Tested

Transmission/Suspension/Brakes/Wheels/Misc.

• Tremec TR6060 Transmission
• SPEC Stage 5 Clutch
• Moton Club Sports Coilovers
• Brembo Gran Turismo Front & Rear 2 Piece Rotor
• HRE 547R wheels (18x10F & 19x13R)
• 5-Point Racing Harnesses

Fuel System & Electronics

• Weldon D2035-A (1800hp)
• Weldon 14000 Fuel Pump Controller
• Precision 95lbs Fuel Injectors
• Aeromotive Fuel pressure Regulator with Gauged
• Upgraded Fuel Rails
• Turbosmart Boost Controller
• AEM Failsafe Wideband/Boost Gauge
• Mopar 2-Bar Map

Asking Price $75,000

 

can't imagine the feelin when those pair of hairdryers on full boost, sweet machine!

 

Thank! Heres what those "hairdryers" sounds like

 

Impressive!!

 

Still for sale?