My Post Pictures

October 14, 2022

18

0

0 2022/10/14 15:41:59 Anders S

Complete compressor

Complete compressor

0 2022/10/14 15:42:59 Anders S

0 2022/10/14 15:44:28 Anders S

0 2022/10/14 15:46:02 Anders S

0 2022/10/14 15:48:14 Anders S

New bearing and pushed in deformations again.

New bearing and pushed in deformations again.

0 2022/10/14 15:49:39 Anders S

0 2022/10/14 15:51:12 Anders S

All cluch parts removed.

All cluch parts removed.

0 2022/10/14 15:51:23 Anders S

Backside of clutch plate

Backside of clutch plate

0 2022/10/14 15:51:34 Anders S

0 2022/10/14 15:51:42 Anders S

Pinout for right turn signal connector to PCB

Pinout for right turn signal connector to PCB

0 2023/01/24 11:42:32 Anders S

Complete servo. To remove arm from shaft just push in the litte clip and pull it of. Plastic tabs around the perimiter keeps the lid on, just pry them open. and remove the lid.

Complete servo. To remove arm from shaft just push in the litte clip and pull it of. Plastic tabs around the perimiter keeps the lid on, just pry them open. and remove the lid.

0 2023/03/02 22:42:52 Anders S

Inside servo. The big plastic gear have the shoe and the pcb with the track hidden under it. Try bending the shoe down a bit too to make sure it contacts the track firmly.

Inside servo. The big plastic gear have the shoe and the pcb with the track hidden under it. Try bending the shoe down a bit too to make sure it contacts the track firmly.

0 2023/03/02 22:42:57 Anders S

Seat track sensor for AM Vantage 2007

Seat track sensor for AM Vantage 2007

0 2023/04/04 14:04:57 Anders S

Made by Pollak for FoMoCo

Made by Pollak for FoMoCo

0 2023/04/04 14:05:38 Anders S

My setup. PC with Picoscope oscilloscope to look at analog voltages and actual CAN data.

My setup. PC with Picoscope oscilloscope to look at analog voltages and actual CAN data.

0 2023/06/19 14:12:39 Anders S

The MCU with a prototyping board strapped under it for DAC's and CAN module. It sure as hell is not pretty but I can lift it up out of the way for the pedals when doing road trials. Used hot glue to make sure every connection stays in place on the board.

The MCU with a prototyping board strapped under it for DAC's and CAN module. It sure as hell is not pretty but I can lift it up out of the way for the pedals when doing road trials. Used hot glue to make sure every connection stays in place on the board.

0 2023/06/19 14:14:04 Anders S

0 2023/07/02 23:53:32 Anders S