Hello members,
I am looking for advice / information on Techart Sway bars.
2003 996 3.6L NA C2 Carrera Aero
My car has the following modifications:
IPD 82 mm Comp Plenum
IPD Silicon Inhaler
BMC Air Filter
Kilne Headers
Kline / Top Gear 200 cell "X" pipe
Tubi Style Mufflers
Evoms Stage IV tune
997 ssk

I have not done any suspension mods yet.
This car is a daily driver and I will be doing Autocross.

I am novice at suspension, so any help / opinions will be appreciated.

Below is the package that I am considering:

096205320009 Anti-Roll-Bar-Kit for 996 C2 all models Manual and automatic transmission
consisting of:
- 1x sport stabilizer front reinforced, not adjustable
- 1x sport stabilizer rear reinforced, triple adjustable
- 2x bearings front
- 2x bearings rear
- mounting kit
- mounting instruction
- TÜV certificate

Manufacturer: Eibach / Production in order of TECHART technical specification

096 FA 096 RA
Series Form Series Form, 3 way adj.
Width 1035 mm 925 mm
Length 225 mm 145 mm
Diameter 23,8 mm 19,0 mm

 

While frankly I have no specific experience with the Techart sway bars, Tarett Engineering has been making what are essentially replicas of the factory GT3 front and rear sway bar kits, and they're a great product. The front bar is 26.8mm and is 5-way adjustable. The rear is 20.7mm and is 4-way adjustable. It's a lot of adjustment, but it means they're good for anything from autocross on street tires to racing on slicks, and give you a lot of control and adjustability for any usage or handling preference in between. They go for $350/axle, and we sell them.