New 991 1/4 Mile Record 8.80: AIM Performance/ES Motor
Thread Starter
|
Registered User
Joined: Oct 2017
Posts: 174
From: Hillsborough, NJ
Rep Power: 64
2. Stock axles. DSS axles on order, but they are not in yet.
Registered User
Joined: Oct 2012
Posts: 645
Rep Power: 52
Yep. New "8SEC DD" license plate has been ordered! 
Thanks!
Yes, the shifts were deliberately early. Was targeting 7000 rpm shift points. Power drops off after that. The 1-2 shift was a bit early at 6k, but wanted to err on that side since if the tires spin on launch you quickly hit the limiter and blow the run. The automatic function still works, but I didn't use it. Joe and Ryan at AIM advised me to manually shift to control the shift points.
Thanks!Yes, the shifts were deliberately early. Was targeting 7000 rpm shift points. Power drops off after that. The 1-2 shift was a bit early at 6k, but wanted to err on that side since if the tires spin on launch you quickly hit the limiter and blow the run. The automatic function still works, but I didn't use it. Joe and Ryan at AIM advised me to manually shift to control the shift points.
Thread Starter
|
Registered User
Joined: Oct 2017
Posts: 174
From: Hillsborough, NJ
Rep Power: 64
Emre is definitely experienced and smart. Probably has a little more in it, since this was the very first and only pass on this build so far, and DA was not optimal. We'll see.
Thread Starter
|
Registered User
Joined: Oct 2017
Posts: 174
From: Hillsborough, NJ
Rep Power: 64
Thank you!
-Dave