Had a Fabspeed installed and started throwing a cel. Light stays on. Durametric says fault code 13 [0135 and 0030] bank 1 02 sensor ahead of....

Now...between the time I ordered 02 sensor and delivery of same, the cel started flashing yesterday. Car started missing and skipping Code was misfires, multiple cylinders [not just one side, across the board]....

Has not flashed today after 10 miles of driving [hoping bad gas].

Question: Does a simple 02 sensor replacement look to be the answer i.e fault codes 0135/0030? here's another dumb question...is bank 1 on driver or passenger side?

Are there any tools/values in Durametric I could check for to better diagnose problem [s], especially misfires? Can I check MAF readings, etc...

Thanks guys.

 

Bank 1 is driver side. your best bet is to get the service manuals on disc.they have all the codes listed and the possible causes and diagnostics. I got mine for about a 100 bucks if i recall but someone posted a link on here a while back with the manulas online for free do a search

 

I did a search and nada. Anyone point me in the right direction on this. Thanks

 

I'm looking for the manuals on disc also.

Free sounds even better.

 

Are you sure the o2 sensors are in the right way round.

 

just the fact that it started to happen after you changed the exhaust and or the O2 sensors... I figure your problems are due to human error.

However, ur cels can be due to fabspeed since it probably has 100 cel cats...
did you correctly hook up the 02senosors... I mean there are 2 on each side.. I hope u didnt put pre in the post ...

 

Here are the free manuals

http://www.cannell.co.uk/Manuals.htm