Can I set this up by putting some sleeves on the struts that prevent it from settling flat on deck of the base i.e an Inch higher

Will this cause probs with the strut motor drive warning light ? Is it easy to take the spolier blade off the struts ?

 

Not a good idea. The system is closed loop, and if the spoiler is attempting to go down and then can't because you've put a spacer in it, the system will throw a fault code and cause stress to the system.

If you really want the spoiler to stay at a specific position, place it there manually using the control switch or get a different spoiler that you like better.

Joe West

 

Dont do it.