P1108 porsche fault code 358 oxygen sensor adaptation lower load range bank 2

I erased the code but then when i went to start the car it would barly stay on it was idling realy rough and blake smoke was coming out the exsaust for about 5 sec and then it cleared up i didnt want to drive for i fear that i may cause some damage. Any ideas what is causing this?

 

P1108 Oxygen Sensing Adaptation, Lower Load Range, Bank
2 – Below Limit

Possible fault cause
♦ Incorrect signal from MAF sensor
♦ Fuel pressure too high
♦ Fuel injector leaking

my guess MAF...

 

Well my car has been running rich. My air fuel ratio gauge sometime stays at 9.3 at full throttle i have a 5 bar fuel reg installed with 65 lbs injecters could this be the problem

 

some one had sugested to change the fuel reg

 

Hay WROSS who makes that wing thats on your car and did it just bolt on to the stock wing lifts?

 

Strosek and yes...fuel problem...could be

 

Is their a web site for that wing

 

I got it 4 years ago in a group buy from Eric @bumperplugs....

 

Thanks Wross. So do you think if i were to go to a smaler fuel reg that might help out my car from running rich!

 

Not sure the fuel problem is that easy....could be your injectors went bad. Doubt it is the FPR, but that would be after injectors.

 

What does RPM say??