Replacing wastegate actuators
Thread Starter
|
Registered User
Joined: Jul 2008
Posts: 239
From: close to the Nordschleife
Rep Power: 28
Replacing wastegate actuators
Hi!
did I miss a DIY somewhere here? I could not find anything with the board search.
I would like to know if there are some pitfalls on the right side, which is not so easy to access?
some pictures?
thx in advance!
did I miss a DIY somewhere here? I could not find anything with the board search.
I would like to know if there are some pitfalls on the right side, which is not so easy to access?
some pictures?
thx in advance!
Registered User
Joined: Jan 2007
Posts: 2,981
From: N. California
Rep Power: 298
check out turboflatsix.com
The bolts are a bit less accessible, but nothing wild... the pressure hose is a *****, heat and time makes it hard to remove and not damage the rubber. Consider tiewraps on the hoses when re-installing.
Calibration is a bit of a challenge, I added my thoughts to the DIY/Tech on TFS
A
The bolts are a bit less accessible, but nothing wild... the pressure hose is a *****, heat and time makes it hard to remove and not damage the rubber. Consider tiewraps on the hoses when re-installing.
Calibration is a bit of a challenge, I added my thoughts to the DIY/Tech on TFS
A
Thread
Thread Starter
Forum
Replies
Last Post
eclip5e
Automobiles For Sale
6
Jul 29, 2019 11:13 AM
r_matt_6
Automobiles For Sale
11
Oct 8, 2015 06:07 PM
vividracing
Ferrari
0
Aug 24, 2015 04:35 PM
