HID Fog Lights installed-good but strange glitch
NOTE: The low headlight beams are set to point really low. For some reason I could only adjust the drivers headlight up and down on the low beam. The passenger side would move very little on the low beam like it was stuck or something. I took it apart and it looked fine and couldn't understand why it wouldn't move much. So in the end I set both low beams at the same height=LOW.
So I installed the fog light HID's to help as I could adjust those equally on both sides no problem. So in the end I have enough light for me to see on the road well. I'll take some more showing the difference with and without the foglights soon.
So I installed the fog light HID's to help as I could adjust those equally on both sides no problem. So in the end I have enough light for me to see on the road well. I'll take some more showing the difference with and without the foglights soon.
If you look at the fog light there is only one wire you connect and its the power. The other ground wire is right next to the opening of the fog light where the bulb goes, just unplug it and plug it into the HID harness side.
I've finally decided that I don't want to take a chance so I'm going to run a relay ASAP until then, no fogs.
I've finally decided that I don't want to take a chance so I'm going to run a relay ASAP until then, no fogs.
Thread
Thread Starter
Forum
Replies
Last Post
RallyBird
Automobiles For Sale
5
Oct 7, 2015 01:20 PM
hacellular
Automobiles For Sale
0
Aug 31, 2015 08:34 AM
ECS Tuning - BMW
Mini Cooper Vendor Classifieds
0
Aug 21, 2015 02:00 PM
ECS Tuning - BMW
Mini Cooper Vendor Classifieds
0
Aug 21, 2015 01:47 PM







