Hey guys,

Been a long time troller and just started posting. I got my 996tt a few months ago and just threw it on the AWD Mustang Dyno.

I did coil plugs and spark plugs first
Car has the following power mods:

Stock K16 Turbos
100 cell 2.5" exhaust
GIAC flash
997.2 GT2RS ICs
IPD 74mm TB/Plenu,
West Coast Crappy 92 Oct

I'll post dyno chart shortly. Anyone want to guess how much power/torque it made?

HI,,You didn't say what type of Dyno,,Rear or AWD?

AWD Mustang Dyno

Oddly enough, I'm not sure if I have ever seen the spoiler move from behind.

Yeah, 4th gear pull to red line, pretty nerve racking, sensory overload in person.

How much boost?
I'm guessing your under 400awhp

+1. I'm digging the rear spoiler and how high it goes, which spoiler is it?

392 awhp - 400 lbs-ft

1 bar of boost, not sure on the spoiler.

I'm thinking you're around 540-550 at the crank, so I'm betting 430-440awhp.

Mustang dyno reads a bit lower so I'll say 430awhp.

What about torque at the wheel guesses?

Should be quite good, 470lbs.ft is my guess.

Well???


When are you going to post the numbers?

435 awhp
498 ft-lbs @ 3000 RPMS!!!

Not bad. Would have been cool to break into the 500 ft-lbs. The ICs look like they are doing a decent job as the runs were pretty consistent.

Khai

Nice!


Looks like Darth and I almost pegged it.


That's a nice setup.


How hard was it to get the IPD plenum on there? I have heard some say the engine needs to be dropped, that sounds a bit ridiculous to me. But then again, I wouldn't doubt it either.


Did you buy the TB/Plenum kit from FVD?