Time for a little makeover
Thanks, yeah the white sticker was a good choice. It look more visible than the black even from a distance. I was at autozone getting ready to buy another can of red caliper paint to do the pinstriping but then I saw this red trim kit that matched perfectly. I went that route instead plus it saved me a lot of time. It's just stick on with 3M double tape. It turns out great IMO.
Last edited by MkC2S; Jun 2, 2014 at 10:54 PM.
thank you !
thanks, yeah it's a few lbs lighter
thanks, yeah it's a few lbs lighter
Depo LED tail lights
next on my list to change was the old tail lights..just received the Depo Led lights & they look awesome IMO..
it's a wee bit pricey but I gotta have it..took less than 10 min to install..while the decklid was up, thought I
checked all the fluids..
these look dated & its time to go


I got the red/smoke version to match the 3rd smoke led brake light


with the driving lights on & switch pulled out for the fog light

is it just my set b/c I don't see the fog light on the left side ? does the Depo light not have fog light ?
it's a wee bit pricey but I gotta have it..took less than 10 min to install..while the decklid was up, thought I
checked all the fluids..
these look dated & its time to go

I got the red/smoke version to match the 3rd smoke led brake light
with the driving lights on & switch pulled out for the fog light
is it just my set b/c I don't see the fog light on the left side ? does the Depo light not have fog light ?
Last edited by MkC2S; Jun 10, 2014 at 09:52 PM.
no I still got a few more mods left on the list for the exterior...I think
Last edited by MkC2S; Jun 11, 2014 at 08:22 AM.
LED DRL lights installed
to install it the proper way, the bumper needs to be remove.
for those that wants to install the 997 GT3 bumper w/signal lights,
you will need to trim a slot about 2.5" x 6" to make room for the signal lights..a few minor trimming to the vent duct and both left & right reinforcement bar.

while the bumper was off, its a good time to clean out the radiator..this explain why my temp gets hotter than normal.

I used a couple home made bracket so the lights would tuck inside the vent



the kit comes with the auto on/off relay


for those that wants to install the 997 GT3 bumper w/signal lights,
you will need to trim a slot about 2.5" x 6" to make room for the signal lights..a few minor trimming to the vent duct and both left & right reinforcement bar.
while the bumper was off, its a good time to clean out the radiator..this explain why my temp gets hotter than normal.
I used a couple home made bracket so the lights would tuck inside the vent
the kit comes with the auto on/off relay
Last edited by MkC2S; Jul 5, 2014 at 12:43 PM.





